|
|
Code
– Z044 and Z045 range
- Click
here to enquire
Webbing straps attached to
the wheelchair is an effective
form of securement. The occupant
should be restrained separately.
NOTE: webbing securement does
not provide the wheelchair
passenger with any form of
back and headrest support.
Simply attach the two front
fixed length pieces of webbing
onto the front corners of
the wheelchair and then locate
into the track. Attach the
two adjustable length pieces
of webbing onto the rear corners
in the same way and then pull
the webbing through the over
centre buckle to create tension.
The stud fittings on these
straps will only locate in
tracking with one inch pitch
holes.
Choose from tongue and buckle
fixings on the wheelchair
or karabiners.
Wheelchair storage strap
Code – B040 - Click
here to enquire
This webbing belt should be
used to secure a folded wheelchair
to the vehicle wall. (side
mounted tracking should be
fitted). One end of the strap
is connected to the wall,
the other to the floor tracking
and then pulled tight through
the cam buckle.
Combined lap and Diagonal
belt and wheelchair restraint Code – MZ086 - Click
here to enquire
This restraint has the rear
adjustable straps attached
to the lap and diagonal belts
and stalk fixture Millennium
fittings to reduce the amount
of space needed for this system.
Code – MIC/STRAP - Click
here to enquire
For those wheelchairs that
have a large diameter tube,
it may be difficult to attach
the straps onto the frame.
This is resolved by using
the Micstrap which is a short
piece of webbing with a ring
at either end. Simply place
around the wheelchair frame
and attach the wheelchair
straps through the rings.
|
|
